MAKING THE CONNECTIONS
When the unit is not operated by the AC power or unused for long period of time,
please remove the power adaptor from the wall outlet and unplug from the unit.
OPERATION
POWERING ON/OFF THE UNIT
1. After connecting the AC power, turn ON the POWER switch on the rear of the
unit, the STATUS indicator will light up in RED to indicate that the unit is in
standby mode.
2. Press the "
3. After using the unit, press and hold the "
unit to standby mode, or turn OFF the POWER switch. The STATUS indicator
will light off.
PAIRING YOUR BLUETOOTH DEVICE
About pairing
Pairing is the term used when two Bluetooth devices are connected wirelessly for the
first time. This allows the devices to see each other and sets up a one to one
communication channel between both devices.
Pairing with a Bluetooth device
1. After powering on your unit, you can start pairing process to connect to your
Bluetooth device.
2. If it is the first time setup after purchasing, the STATUS indicator will flash RED
and BLUE alternatively to ask for pairing, BLUE/RED flashing indicates pairing
attempt is in process.
3. Turn on Bluetooth functionality on your device and make it discoverable (see
your device's instructions to add or setup a Bluetooth device).
4. Select CE7000-BT on you Bluetooth device to make the pairing when it is
found. If you device asks for a passkey, enter "0000" on the keyboard of your
device. If no device is paired in 3 minutes, the unit will power off (switch to
standby mode). If this occurs, retry step 1 - 4.
5. Once paired with a device, a blue light on the STATUS indicator will glow
steadily and two beep sounds confirms that pairing is completed. On some
devices, you must then select "use as a stereo audio device" or similar on the
device's Bluetooth manual. Once paired, your device should connect to the
CE7000-BT whenever within the Bluetooth range (10 metres).
All manuals and user guides at all-guides.com
" button once to turn on the unit.
" button for 2 seconds to switch the
8