Bestway 58156 Manual Del Propietário página 4

Installation Directions
Part I Pedestal Fixing (See Fig.1)
The pool heater must be vertically fixed on ground or a certain pedestal made of wood or concrete before it can be used. There should be two holes,
6mm in diameter on the pedestal, the space between which should be 198mm. Put the pool heater on the pedestal and fix them together with bolts
and nuts. The pedestal should weigh over 18kgs in order to prevent the pool heater from accidentally falling.
Fig.1
Part II Assembly (See Fig.2)
Fig.2
P6176
INLET
P6124
P6005
Illustration (not to scale) of Pool and Filter Pump and the Pool Heater
1. Set-up and fill the pool with water to the required level according to the pool's owner's manual.
2. Attach the Filter Pump's Inlet Valve to the Pool:
a) Place the loose Hose Clamps on both ends of a Filter Pump Hose.
b) Attach the hose to Filter Pump's Inlet Valve and the Pool's Outlet Valve.
c) Tighten the Hose Clamps.
3. Connect the Filter Pump to the Pool Heater:
a) Place the loose Hose Clamps on both ends of the Pool Heater Hose.
b) Attach the hose to the Filter Pump's Outlet Valve and the Pool Heater's 'INLET' Valve and tighten the Hose Clamps.
4. Attach the Pool Heater to the Pool.
5. Loosen the Hose Clamps on the Pool's Inlet and Outlet Valves; replace the Stopper Plugs with Debris Screens. Water now flows to the Filter
Pump and the Pool Heater. With the Hoses and the Debris Screens in position, tighten the Hose Clamps.
6. Check that every port and valve is connected correctly.
Operation
1. Check the pool for correct installation and make sure both the pool's Inlet and Outlet Valves are fully covered by water before operating the Filter
Pump of the Pool Heater. Make sure that the Pool Heater and Filter Pump are correctly connected.
2. Open/unscrew the Air Purge Valve on the top of the Filter Pump; air is released as water enters the Filter Pump. When water comes out of the Air
Purge Valve, close it and wipe away any water.
3. To start the Filter Pump, insert the plug into a grounding type receptacle protected by a RCD.
NOTE: Never plug-in the Pool Heater until the Filter Pump has been plugged in.
NOTE: To prevent the risk of electrical shock, ensure your hands are completely dry when plugging-in the Filter Pump and the Pool Heater.
NOTE: To prevent the risk of electrical shock, never run the Filter Pump and the Pool Heater when people are in the pool.
All manuals and user guides at all-guides.com
Air Purge Valve
Inlet
B
P6124
Outlet
A
Filter Pump
P6124
OUTLET
P6005
P6124
Pool Heater
4
P6124
Inlet Valve
>1/2 inches
Debris Screens
Outlet Valve
(F4030)
Bestway
®
S-S-000833