Set Time And Date - J.P. SELECTA FRIGITERM TFT-10 Manual De Instrucciones

INSTRUCTION MANUAL
LANGUAGE DATE/TIME
INSERT
CONTRAST
PASSWORD
Fig 1. Programming screen
Selected program.
PROGRAM 00
TEMPERATURE: 16.0ºC TIME: 00:00
UNDERTEMP: 0ºC OVERTEMP: 0ºC
SETUP
Fig 7.3. Programming screen.
J
.P. SELECTA s.a.u. - Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
CODE 80324 REV 0
7.2 Programming screen
UNITS

7.2.1 Set time and date

CHANGE
Press on Date/time button.
PASSWORD
Press over push buttons to set time and date.
Use Up and Down icons to entry a value.
CAL
7.2.2 Set temperature, language and screen contrast
In a similar way set the temperature, language and screen contrast.
7.2.3 Working parameters protected under password
Some parameters settings are password protected.
Temperature calibration.
....
7.3
Up to 8 programms of temperature and time can be stored.
Each program has the following parameters:
Temperature:
Time:
Undertemp:
Overtemp:
From main menu press over «PROGRAMMING».
Program selector.
Fig7.3 screen is displayed.

Select a program (from 00 to 07) with keys:
SEL
Set working temperature and the other parameters:
Press:
SAVE
keys
HH:MM:SS DD/MM/YY
In a similar way press:
UNDERTMP: 0ºC
OVERTMP: 0ºC
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
Nov/2015
Temperature and working time setting
Temperature: from ambient+5ºC ... 200ºC
HH:MM
Alarm value for temperature drop.
Alarm value for overtemperature.
TEMP: 16.0ºC
will be shown to select temperature.
Sets de working time.
TIME: 00:00
A time setting value of 00.00 means «conti-
nuous operation».
Sets the undertemperature alarm value.
Sets the overtemperature alarm value.
Press
(It can be modifi ed without notice)
to save .
SAVE
Page: 14