Altec Lansing Octiv M650 Guia Del Usuario página 8

Getting Started
How to Connect the Full-Featured Remote Battery
The remote battery (included) will need to be installed before the remote will
function; in order to do this please follow the instructions below:
1
Pull the battery holder out about halfway.
The battery holder is located on the lower end of the back of the
remote. Use a fingernail to pull the latch toward the centerline of
remote while using another fingernail to simultaneously pull the
battery holder out of the remote.
2
Remove the battery from the plastic bag where you found the
remote and insert into the battery holder so that the "+" sign is
facing up.
3
Push the battery holder back into the remote, making sure the
battery stays in place.
You will hear and feel the latch click.
Please discard used batteries properly.
NOTE
6
All manuals and user guides at all-guides.com
How to Dock Your iPhone or iPod
Place your iPhone or iPod into position.
Align your iPhone or iPod's connection port
with the dock connector on the Octiv 650
speaker system. Slide your iPhone or iPod
onto the dock connector.
How to Turn On Your Speaker System
1
Make sure you have power to the unit.
Ensure the AC adapter is connected to the
system and plugged into the wall. See the Getting Started section for
more information.
2
Turn the unit on.
Press the button on either the speaker system or the remote.
How to Turn Off Your Speaker System
Turn off the unit.
Press the button on either the speaker system or the remote.
After a few minutes of no use, the speaker system will automatically
NOTE
turn itself off.