HTW -CLE-11NOXUAGLP-K Manual De Usuario E Instalacion página 46

● Finish the above mentioned preparation and conFinish the above mentioned preparation and
confirm before using, sign before using.
Press the ON / OFF key on the operation panel, the LED will show the default water outlet
● ●
temperature of 4 ℃, press the
Temperature
decrease key
4.2 Ignition and operation
● Ignition: Open the water outlet valve, the unit will start the exhaust device automatically and make an
ignition sound like "sizzle"; the LED will show the current temperature of the water outlet. When the
unit is running, there will be air in the gas line; therefore, a single ignition may sometimes not work.
In that case, immediately close the hot water valve and restart the unit after 10-20 seconds.
When using for the first time or has not been used for a long time, operate as above
repeatedly, all the air in the exhaust pipe has been discharged.
Water outlet temperature settings: The default range of the w a ter outlet temperature is 35℃ ~ 65 ℃.
●
Each time the Temperature Increase key is pressed, the set temperature w i ll increase to 1℃, each
time the Temperature Decrease key is released for 2 seconds, the display w i ll show the temperature
of the measured w a ter outlet.
The configured water outlet temperature has a memory function. However, in case of power outage,
●
the memory function will be disabled.
Immediate sound function: Under normal circumstances, each time the key is pressed on the
●
operation panel, the buzzer will make a 0.5 second sound. When the unit fails or ends the 20 minute
timing protection, the buzzer will emit continuous alarm sounds, the combustion indicator will flash
rapidly and continuously. Press the ON / OFF key, the alarm will disappear and the screen will close,
but the power indicator will not go off (green).
Use multi-line controllers: The priority principle will apply to the use of multi-line controllers,
whichever is indicated first will take priority, while the priority controller power indicator will flash, the
●
remaining priority controller will also flash, the other controllers they can be displayed but will not
operate; the screen will be the one with priority. When the priority controller is turned off, the
remaining controllers screen will close.
/ key to set the hot water outlet temperature.
Outlet water temperature
indication
Temperature increase key
NOTE
18
ON / OFF key
Burning indication