Power Supply; Power On The Camera - Bresser 9630200 Instrucciones De Uso

OFF position before testing the camera. The camera has
no internal memory for saving images.
• Please do not insert or take out the SD-card when the
power switch is at ON position.
• It is recommended to use the camera to format the SD-
card when used for the first time.
• The camera will be in USB mode when connected to a
USB port of a computer. In this case, the SD-card func-
tions as a removable disk.
3. Main operations

3.1 Power supply

To supply power for the camera, at least four AA size bat-
teries are needed.
ATTENTION!
The manufacturer does not take any liability for any damag-
es caused by a wrong insertion of batteries.
ATTENTION!
Make sure that the power switch is at the OFF position.
Open the battery compartment door and remove the battery
tray, by turning the two holders to the side. Install the fully
18
All manuals and user guides at all-guides.com
charged batteries into the battery tray according the polar-
ities shown. Re-Insert the battery tray. Pay attention to the
correct orientation (see illustration).
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
3.2 Insert the SD-card
Open the battery compartment door. Insert the microSD
card into the card slot with the unmarked side facing
upwards. Please note that the microSD card can only be
plugged in in one direction. Make sure that the write-pro-
tect switch of the SD-card is in the "write" position; other-
wise the camera cannot be switched on.

3.3 Power on the camera

Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances in front of
(Recommended)
the camera such as big leaf, curtain, air-conditioner, air
outlet of a chimney or other heat sources to prevent
false triggering.