What's In The Box; Power On/Off; Video Recording - Wiseup T182 Manual Del Usuario

All manuals and user guides at all-guides.com
II. What's in the Box
-1× Mini DIY Camera Module
-1× 2.4GHz Remote Controller
-1× USB/AV Cable
-1×AC110-230V to DC 5V Charging Adapter
-1× 8GB Micro SD Card (fitted into the Micro SD card slot already)
III. Operation
>> Please make sure your camera battery is fully recharged and connected to the camera
before using.
>> Please make sure the Micro SD card (4GB-32GB, formatted already) is securely fitted
into the camera's SD card slot, or it will not work. A SDHC Class 10 Micro SD card is
recommended. If no Micro SD card is fitted into the camera, the indicator light will flash
red and blue 14 times, then turn off. The camera will shut down automatically.
>> If you want the camera to provide 24/7 service, please remove the battery and connect
the camera to power supply directly.

3.1. POWER ON/OFF

3.1.1. Slide the Power Switch to the ON position (opposite to the USB port). Power on the
camera by pressing the Power Button or Button A for 2 seconds. The indicator light will
flash red and blue once, turn off, then glow solid red, indicating the camera has entered
into standby mode automatically.
3.1.2. Power off the camera by pressing the Power Button or Button A for 2 seconds
again. The indicator light will flash red and blue 3 times, then turn off.
[Note]:
The camera will shut down automatically if it is in standby mode without any operation
more than 2 minutes.

3.2. VIDEO RECORDING

3.2.1. Slide the Power Switch to the ON position (opposite to the USB port). Power on the
camera by pressing the Power Button or Button A for 2 seconds. The indicator light will
flash red and blue once, turn off, then glow solid red, indicating the camera has entered
into standby mode automatically.