Brandani 57286 Manual De Instrucciones página 14

Operation
Place the heating base on a fi rm and level surface.
Pour the desired amount of clean water into the kettle. Do not touch any part of the kettle except
the handle when the appliance is in use, and ensure that the lid is properly closed. The amount of
water can be measured by the level mark on the outside of the kettle. Always pay attention to the
minimum and maximum levels and ensure that the lid is properly and fi rmly closed.
Position the kettle in such a way on the base that the underside of the kettle fi ts precisely into the
contact unit on the base.
Insert the plug into a wall socket.
Put the 0/1 switch to its 1 position to start the heating process. The indicator lamp will light up.
As soon as the water reaches boiling point, the 0/1 switch return automatically to the'0' position.
The indicator lamp will go out. The water kettle can also be switched off manually by putting the
0/1 switch to the 0'position.
The hot water may now be poured safely through the spout into another container.
Safety cut-out
This kettle is equipped with a safety cut-out to protect the appliance from damage in case of unap-
propriate use. Should the appliance be accidentally operated without water, or if all the water has
evaporated, the safety cut-out will automatically switch off the heating element
In such a case, remove the plug from the wall socket immediately and refi ll the kettle only after an
adequate cooling down period. About 15-20 seconds
14
57286.indd 14 57286.indd 14 6-08-2008 14:10:56 6-08-2008 14:10:56