Remote Control Unit; The Control Panel - Dolphin WAVE 100 Instrucciones De Manejo

7. REMOTE CONTROL UNIT

The remote control unit (RCU)
offers two operation modes –
Automatic mode and manual
direction control mode.
In automatic mode, the
cleaning parameters can be
changed.
In manual direction mode,
the robot's motion can be
controlled manually.
Manual Direction Control Mode
Exiting Manual Direction Control Mode and setting the Automatic Mode
Dolphin WAVE 100 Pool Cleaner | Operating Instructions
8151637_Book.indb 9

The Control Panel

1. Press the On/Off button once. The remote control will start in
manual direction control mode.
2. Use the direction control arrows (see right) to control the
movement of the robot around the pool.
1. To exit the manual direction control mode, press the
Manual/Automatic select button once only.
2. The digital screen will light up and three rows of function
icons will be displayed in default mode.
1. To change the parameters press the up or down arrows.
2. To select the parameter settings use the right or left arrows.
When you reach the required function press the Set/OK
button.
Radio reception meter
When no black lines are showing, move
closer to the power supply unit
Battery level meter
When flashing, change the batteries
Manual control indicator
When flashing, you are in manual direction
control mode
Cleaning cycle icons
Delay timer icons
Cleaning mode icons
ON/OFF button
Manual/automatic select button
Set/OK button
Direction control arrows
9
29/12/2013 10:00 AM