Publicidad
Idiomas disponibles
Idiomas disponibles
English
3
Assembling the Unit
NOTICE
The solution hose and throttle cable are already
connected and must not be kinked while assem‐
bling the machine.
The combination wrench and screwdriver are in
the supplied accessory bag.
3.1
Fitting the pleated hose on the
blower tube
1
► Push wide hose clamp (1), marks facing right,
onto the blower tube (2).
4
► Push the ring seal (3) (wide lip facing left) onto
the stub on the blower tube (2).
► Push the pleated hose (4) over the ring
seal (3).
4
► Push the hose clamp (1) onto the pleated
hose (4).
34
2
2
3
2
1
5
► Line up the marks on the hose clamp (1) and
blower tube (2) – as shown.
► Secure the hose clamp (1) with the screw (5) –
the blower tube (2) must still rotate.
3.2
Fitting the Pleated Hose on the
Elbow
1
2
► Push narrow hose clamp (1), marks facing left,
onto the elbow (2).
► Push the pleated hose (3) onto the elbow (2).
2
4
2
4
1
► Push the hose clamp (1) onto the pleated
hose (3).
► Line up the marks on the hose clamp (1) and
elbow (2) – as shown.
► Secure the hose clamp (1) with the screw (4).
3.3
Adjusting and Securing the
Control Handle
► Put the machine on your back and adjust the
harness – see "Harness".
3 Assembling the Unit
3
1
3
0458-450-8721-C
Publicidad
Capítulos
