Publicidad
SCOPE OF DELIVERY AND ASSEMBLY
1
Premark drill holes on the wall where the sunblind is to be hung.
Use the brackets (C) as a template. The lower bracket should be
placed about 20-30 cm above the ground, the second at a height of
120 cm (10028008/13/14), 140 cm (10028015/16/17) or 160 cm
(10028018/19).
2
Drill with a 6 mm drill bit. Make absolutely sure beforehand that there
are no gas, water or electrical lines running in the wall.
3
Attach the mounting brackets (C) to the wall with the screws and dowels
provided (or with an alternative more suitable for the specific surface) as
shown in the sketch.
4
Attach the sunblind to the mounting brackets.
5
Place the pole (B) at the desired location, maximum 3 metres from
the wall bracket (= length of the awning) and use its base plate as a
template for the drill holes in the ground.
6
Drill with a 6 mm drill bit suitable for the substrate.
7
The M6 metal frame plugs supplied are suitable for concrete, solid,
perforated brick and aerated concrete, also with wood or similar
panelling. Use it to screw the pole to the ground.
8
Extend the sunblind.
9
Hook it into the pole.
EN
5
Publicidad
