allen+roth YIC-555 Manual Del Usuario página 3

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
No Tools Required for Assembly
ASSEMBLY INSTRUCTIONS
1
Place the basin with stand pipe (B) in a
convenient place where it will not have
to be moved after assembly but still
within reach of a GFCI electrical outlet.
Very carefully lay the fountain urn (A) on
its side with the bottom facing the basin
with stand pipe (B) and attach the water
feature tube (D) to the top of the pump
with electrical cord (C).
Place the pump's electrical cord down
2
through the stand pipe opening. Pull
the cord through and out the bottom of
the basin until there is just enough of
the electrical cord inside the basin to
allow the pump to sit flat on the bottom
of the basin.
Lift the fountain urn (A) upright and be
3
careful not to kink the water feature tube
(D). Place the fountain urn (A) over the
pump with electrical cord (C) and basin
with stand pipe (B)
Fill the basin 2/3 full of water; plug in
4
the pump. If you want to change the
water flow, unplug the pump cord from
the electrical outlet and turn the pump's
flow control left or right.
Fig. 1
B
Fig. 2
Fig. 3
D
C
Fig. 4
3
D
A
C
A
B
D
C
A
B
C