Storage; Troubleshooting - Steinbach Split Manual Original

1. Unscrew the top part of the tank
from the bottom part of the tank
and remove the top part.
2. Unscrew the screws from the product
base.
3. Drain the remaining water from the
tank.
4. Screw the drain cap onto the tank.
The product is dismantled.

Storage

To store the product, proceed as follows:
1. Thoroughly clean the product (see section "Cleaning").
2. Let all parts dry completely.
3. Then store the product and accessories in a dry, frost-free place (≥ +40 °F/+5 °C).
The product is stored.

Troubleshooting

Fault description
Water is still coming out of the
shower head even after the
faucet has been closed.
Water is leaking from a screw
connection.
There is no water coming out
of the shower head.
11
1
4
12
Cause
This is caused by the water
heating up in the
unpressurized tank.
The screw connection is not
water-tight.
No water is being supplied.
4
Remedy
It is not a defect!
Wrap the thread in Teflon tape.
Check the water supply.
Check the garden hose for
blockages and damage.
1
39