Tripp-Lite DWM2355S Manual Del Usuario página 5

1b. Mount on Solid Brick or Concrete Block
1b
• When installing wall mount onto a concrete masonry unit (also known as a CMU or cinder block), verify
the actual concrete thickness is at least 1-3/8" (35 mm) in order to hold the concrete anchors. DO NOT
DRILL INTO MORTAR JOINTS! Be sure to mount the assembled wall-mount plate with the included concrete
anchors, D6 washers and anchor bolts onto solid sections of the blocks. The solid sections can generally
be found 1" (25 mm) toward the middle of the block from either end. An electric drill on a slow setting is
recommended to drill the hole rather than a hammer drill to avoid breaking out the back of the hole when
entering a hollow section.
• The installer must verify the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
WARNING
5
65mm
60mm
(2.4")
() 2.6"
1
10mm
Ø
( 3/8")
Ø
1
Find and mark the
exact location of
mounting holes
2
Drill pilot holes
Ensure holes are level
Screw mount
into wall