Perel WHPC03 Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Never operate the machine without all components properly connected to the machine (handle, trigger
gun, spray nozzle, etc.).
WARNING: EQUIPMENT DAMAGE
• ALWAYS turn the water supply "ON" before turning the pressure cleaner "ON." Running the pump dry
causes serious damage.
• Do not operate the pressure cleaner with the inlet water screen removed. Keep the screen clear of
debris and sediment.
• NEVER operate the pressure cleaner with broken or missing parts. Check the unit regularly and have
worn or damaged parts replaced immediately.
• Use only the nozzle supplied with this machine.
• Never leave the wand unattended while the machine is running.
• Never attempt to alter factory settings. Altering factory settings could damage the unit and will void
the warranty.
• Always hold the gun and wand firmly when starting and operating the machine.
• NEVER allow the unit to run for more than one (1) minute without spraying water. The resulting heat
build-up will damage the pump.
• The pressure cleaner is not meant to pump hot water. NEVER connect it to a hot water supply as it will
significantly reduce the life of the pump.
• NEVER store the pressure cleaner outdoors or where it could freeze. This would seriously damage the
pump.
• Release the trigger when you want to change the pressure setting. Failure to do so could result in
damage.
• Install an additional sand filter (not incl.) when using water from a different source than the potable
water mains.
CAUTION
• Keep the hose away from sharp objects. Bursting hoses may cause injury. Examine the hose regularly
and replace it if damaged. Do not attempt to repair a damaged hose.
DANGER: EXTENSION CORDS
• Use only grounded three-wire extension cords that are in good condition.
• Use of an extension cord is not recommended. Use only extension cords intended for outdoor use.
• Use only extension cords with an electrical rating equal to or higher than the rating of the device.
• Examine the extension cord prior to use and replace it if damaged.
• Do not pull on the cord to disconnect the device from the mains; pull the plug instead.
• Keep the cord away from heat and sharp edges.
• Always disconnect the cord from the receptacle before disconnecting the device from the extension
cord.
• Failure to follow these instructions can result in serious injury, including death.
• Keep all connections dry and off the ground to reduce the risk of electrocution. Do not touch plug with
wet hands.
3. Features
• ideal for thorough cleaning of stone, wood, metal and plastic materials
• integrated hose reel with 5 m high-pressure hose
• with automatic motor shut-off
• comes with soap dispenser bottle and high-pressure lance with adjustable nozzle and spray gun
4. Connection
Refer to illustration A on page 2 of this manual.
1
pressure cleaner
2
water supply hose (not incl.)
3
water connection
4
water inlet
How to mount your high-pressure cleaner:
• Attach the hose to the water outlet of the cleaner.
• Attach the spray handle to the high-pressure hose. Prior to operating the machine, please ensure that
the high-pressure hose has been completely uncoiled. Make sure the hose DOES NOT loop during
operation.
• Attach the nozzle or other equipment to the gun.
• Connect the machine to the water and power supplies. Use an inlet hose (not incl.) of at least 1m long
and capable of withstanding a pressure of 0.8MPa.
27.04.2010
WHPC03
5
high-pressure tube
6
water outlet
7
spray gun
8
power supply
4
Rev 03
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido