Ceado E37J Manual De Uso Y Mantenimiento página 33

GB
Press the button
and French. Press the button
Start button setting
According to the factory setting, the appliance distributes coffee only as long as the start button
(11 Fig. 1) is held down.
If this button is released during distribution of a shot, the motor stops, the system goes into pause
status and the display shows the time remaining to complete the shot and the message
"WORKING". In addition, to highlight the fact that the distributed shot has not been completed, the
LED for the shot selected flashes. At this point, to complete the dose just press the start button
(11 Fig. 1) again with the filter-holder and keep it pressed until the shot is completed.
Instead, if you no longer wish to complete the dose, press one of the shot buttons
or to cancel the current shot and return the system to READY position.
However it is possible to change this function by programming the start button (11 Fig. 1) in pulse
mode or "dose with start" mode. With pulse mode the distribution of coffee will begin with the
simple pressing of the start button (11 Fig. 1) and will end only at the end of the time set for the
distribution of the required shot. With "dose with start" mode the distribution of coffee will begin as
a single dose with the single pressing of the start button (11 Fig. 1) or the distribution of coffee will
begin as double dose with quickly double pressing of the start button (11 Fig. 1). Also in this case
the distribution of coffee will end only at the end of the time set for the distribution of the required
shot.
To change the operating mode of the start button, press the button
displayed:
Press to confirm. The display will show:
Press the button
Fan mode setting (available only in models E37SL and E37T)
The appliance leaves the factory with a temperature automatic regulation system that operates a fan
only when it is needed. However, you can change this setting and keep it running continuously.
Hold down the button
until this screen is displayed:
or to select one of the 5 languages: Italian, English, Spanish, German
to confirm.
or to set the function "pulse ON", "pulse OFF" or "dose with start".
for 3 seconds to enter the settings menu. Then press the button
33
until this screen is
or