Attaching The Auxiliary Handle - RIDGID RD80944 Manual Del Operador

Lavadora a presión de 3 000 psi
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
INSTALLING TRIGGER HANDLE HOLDER
See Figure 4.
 Insert trigger handle holder into holes in handle, as shown.
 Thread screw through holder and into handle. Tighten
securely.
ATTACHING HOOK AND LOOP HOSE STORAGE
STRAP
See Figure 5.
 Locate the slot in the top of the nozzle storage panel.
 Slide hook and loop strap into slot and buckle.
 Neatly coil the high pressure hose and store with hook
and loop strap.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 6.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the wand in place.
 When not in use, remove the spray wand from the trigger
handle by turning the connector counterclockwise. Store
the unassembled spray wand in the spray wand storage
area.

ATTACHING THE AUXILIARY HANDLE

See Figure 6.
 Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown. Turn clock-
wise to tighten.
NOTE: You can install the handle on either the left or right
side of the spray wand, depending on operator prefer-
ence.
 To switch sides, loosen the auxiliary handle and rotate to
the opposite side. Tighten securely before use.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 7.
 Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
 Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 8.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using The High Pressure Hose in Operation
for more information about using the high pressure hose.
 Insert the inlet coupler on the end of the high pressure
hose into the collar until it clicks in place and is secured
properly.
 Pull on the hose to be certain it is properly secured.
9 - English

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido