Premium; Menu Setting & Functions - Biosynex ThermoFlash Premium Manual Del Usuario

VI. MODALITIES AND START-UP OF THERMOFLASH PREMIUM®
1. Install the batteries.
2. When the batteries are used for the first time or when inserting new batteries,
wait about 15 minutes for the device to reach room temperature.
3. Aim the device at the temporal lobe or a side/temple, as shown (SEE DIAGRAM
A
PAGE 2), at a distance of 2 to 5 cm / 0.79 - 1.97 in press the measurement
key, the temperature is instantly displayed. The temperature can also be taken
behind the ear lobe - on the jugular vein.
VII. MENU SETTING & FUNCTIONS
1. Choice of temperature display mode
Body mode: Measurement of the body temperature.
Measuring range: 30°C to 43°C / 86°F to 109.4°F
Surface mode: Measurement of the surface temp of an object or food.
Measuring range: : 0°C to 90°C / 32.0°F to 194°F
Room mode: Measure the ambient temperature of a room.
Measuring range: 0°C to 50°C / 32°F to 122°F
Press the measurement button to turn on the device.
Press MODE button to select the temperature measurement mode.
The screen displays: Body mode - for body temperature measurement. Press the
MODE button again to switch to SURFACE mode. The screen displays Surface.
Press the MODE button again to switch to ROOM mode. The screen displays Room.
Note: the THERMOFLASH® Premium is automatically set to BODY.
IMPORTANT: The area temperature differs from the internal body temperature.
Use BODY mode only to obtain the internal body temperature.
2. Choice of temperature unit
Press the °C/°F button to select the temperature unit. The screen, displays the
symbol of the selected unit (°C for degrees Celsius, °F for degrees Fahrenheit).
3. Data memory
Press the MEM key to view the last temperature measurements. The first record is
the last temperature measurement, total memorize 32 sets.
Record number will display first, followed by the temperature. Continue pressing
to cycle back through the 32 most recent measurements made.
4. Alarm threshold
The alarm threshold is set to 38°C. This cannot be changed. If the temperature is
over 38°C, a beep sounds during the temperature measurement.
5. Changing the batteries
When the
Operation: Open the cover and replace the used batteries taking care
to observe polarity. A polarity error may cause damage and void the
guarantee. Do not use batteries other than the batteries mentioned,
do not recharge non-rechargeable batteries, or throw them into a fire.
Remove the batteries when not using the device for a long period. Use disposable
batteries.
20
LCD screen displays , the battery is used.