HAMPTON BAY 186 977 Manual Del Propietário página 7

end of the bolt until it snaps into its
locked position, as noted in the circle inset
of Figure 7.
6. Re-tighten the set screws on the collar on top
of the motor housing (Figure 8).
FAILURE TO PROPERLY INSTALL CLEVIS PIN
AS NOTED IN STEP 6 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
7. Make sure the grommet is properly installed
in the collar cover, then slide the collar cover
on the downrod until it rests on the motor
housing. Be sure that the canopy and the col-
lar cover are both oriented correctly.
8. Proceed to "Installing the Fan" section.
"Close-to-Ceiling" Mounting
1. Remove canopy ring from the canopy by
turning the ring to the right until it unlocks
(Figure 5).
2. Remove the mounting plate from the canopy
by loosening the four screws on the top of the
canopy. Remove the two non-slotted screws
and loosen the slotted screws. This will enable
you to remove the mounting plate (Figure 6).
All manuals and user guides at all-guides.com
3. Remove the decorative canopy bottom cov-
er from the canopy by depressing the three
studs (Figure 9).
Canopy
Bottom
Cover
Figure 8
4. Remove three of the six screws and lock
washers (every other one) securing the mo-
tor collar to the top of the fan motor housing
(Figure 10).
5. Place the
remaining three screws, route the wires
exiting the top of the fan motor through the
canopy ring (make sure the slot openings
are on top), then proceed to place the ceiling
canopy over the collar at the top of the motor
(Figure 11).
6. Align the mounting holes with the holes
in the motor and fasten, using the three
screws and lock-washers removed in
step 4 (Figure 11).
7. Tighten the mounting screws securely.
Figure 9
rubber gasket over the
Motor
Collar
Screw and
Lockwasher
(3 of 6 places)
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 7 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
Figure 10
Figure 11
5.