VONROC GG502DC Traducción Del Manual Original página 6

EN
LED Charger status
Red Battery charging in progress.
Green Battery charging finished, battery fully
charged.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
small plug from the base.
• Fully charging the battery may take up to 2 – 3
hours.
Inserting glue sticks (11) (Fig. D)
Always use the correct diameter glue stick.
1. Insert a glue stick through the opening at the
back of the glue gun.
2. Guide the glue stick into the glue chamber until
it stops.
The glue gun will stop dispensing glue when the
glue stick in the chamber is almost used up. To
refill the chamber, set the glue gun in the base and
insert a new glue stick.
Switching the machine on and off (Fig. A)
• Press and hold the on/off switch (5) to turn on
the glue gun until the heat up LED indicator (4)
will light on in RED.
• Allow approx. 25 seconds for the glue to melt
and reached the operating temperature and the
heat up LED indicator (4) will turn green.
• The glue gun is ready for use.
NOTE: The heat up LED indicator appeared RED and
you feel resistance from the trigger during applica-
tion, then the glue gun will be required to reheating
for a few seconds.
Using the glue gun
• Hold the glue gun firmly and place the nozzle
close to the surface where glue will be applied.
• Pull the trigger (1) until glue flows from the
nozzle (3), do not over-apply.
• When the desired amount of glue has been ap-
plied, release the trigger (1). Tilt the nozzle (3)
slightly to the side and carefully pull the nozzle
away from the object. This helps avoid strings
of glue clinging to the work.
6
• Between application use the base to tempora-
rily store the glue gun, glue gun will automati-
cally charge.
NOTE: The glue gun will be automatically shut-off
after approximately 5 minutes if not in use. You
need to press the ON/OFF switch to restart.
Using the drip tray
• The built-in drip tray (9) on the base (2) will
catch any drips while the glue gun is heating or
cooling down.
• With your hand, simple to slide the drip tray out
from base. Like shown in figure E.
NOTE: Always turn the glue gun off and place on its
base when you are finished using the glue gun.
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Remove very persistent dirt using a soft cloth mois-
tened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
Clean the glue gun metal contact
Always check before each use to see that the
metal contacts are clean to give a best contact
performance when charging. Any residue should
be cleaned from the metal contacts using the
following steps.
1. Remove the glue gun from the base and set
aside.
2. Carefully scrape the cooled glue from the metal
contacts using a cotton swab or any non-metal-
lic utensil.
Be sure to check the contacts on both the glue
gun and the base for any glue residue. Never use
metallic utensils to clean the contacts.
WWW.VONROC.COM