Additional Building Instructions - THINK GIZMOS RUBBER BAND TARGET SHOOTER Manual De Usuario

4. ADDITIONAL BUILDING INSTRUCTIONS

1. PAGE HEADER
4.1 Additional Building Instructions
5:
Notice: Ensure the Receiver Hook part is installed facing the correct direction.
9a:
The board will bend slightly when fitting into part E2. Pay attention when assembling to not
snap the part.
9b:
1. Bullet Hook.
2. Receiver Hook.
3. Fore-end.
4. Trigger.
Shooting tips:
1. Load 2 rubber bands per shot on the bullet hook and receiver hook. Rotate the hook gear
to load another shot. 5 Shots in total can be loaded.
2. Slide the fore-end back to ready the shot.
3. Aim, Pull the trigger. Fire!
5