Listening To The Fm Radio; Tuning In A Station; Presetting Stations; Tune To A Preset Radio Station - Vieta Home VH-MS350SL Manual De Usuario

Listening to the FM Radio

Tuning in a Station

1 Ensure that you have connected and fully extended
the FM antenna.
2 Press the TUNER button to select the TUNER source.
3 Press the 5/6 buttons, the frequency changes
down or up automatically until a station is found.
Or press / buttons repeatedly until you find the
 
station you want.
Note:
- You can press 12 PLAY button on front panel
to search stations or press and hold 12 button
on the remote control to change grid.
- The unit will automatically switch the Stereo or
MONO channel to receive the FM radio mode, it
can get the best effect.

Presetting Stations

You can preset up to 20 FM stations.
Program radio stations automatically

Press and hold the PROG button for 2 seconds to
activate automatic programming. All available stations
are programmed in the order of waveband reception
strength.
- The first programed radio station is played
automatically.
Program radio stations manually

1 Tune in the desired station, then press the PROG
button.
2 Press the 0~9, 7 or 8 buttons to select the
preset number.
- 0~9 Select the preset number directly
- 7 Decreases the preset number by 1
- 8 Increases the preset number by 1
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station you
want to store in memory with a preset number.
5 Press and hold the 3 button to erase the memory
radio stations.
Note: If the system is unplugged or if a power failure
occurs, the preset stations will not be erased.

Tune to a preset radio station

Press the 7 or 8 buttons to select a preset number
that you want.
Note: You can also use the numerical keypad to se-
lect a preset station directly.

RDS Timer Sync

When a RDS station is found, time of the unit will get
out of sync with the RDS time.

Show RDS information

RDS (Radio Data System) is a service that allows FM
stations to show additional information. If you tune to a
RDS station, RDS and the station name are displayed.
1 Tune to a RDS station.
2 Press the MENU button repeatedly to scroll through
the following information (if available):
- Station name .
- Program type such as [NEWS] (news),
[SPORT] (sport), [POP M] (pop music)...
- Frequency
- RDS Clock

Other features

Set the Clock

In standby mode, press and hold CLOCK button to
activate clock setup
-
Hour digits begin to blink
Use / button to set hour, then press CLOCK
 
again.
-
Minute digits begin to blink
Use / button to set minute then press CLOCK
 
to confirm clock settings.
Note:
You can synchronize this unit's clock with RDS station
and iPad/iPhone/iPod.
In standby mode, press and hold SETUP button.
"CLOCK SYNC MENU" scrolls on VFD, followed by a
sync mode for selection
Use / to select a clock synchronization mode and
 
ENTER to confirm selection
RDS:
sync clock with tuned RDS station automatically(if
RDS signal include time data)
iPod:
sync clock with connected iPad/iPhone/iPhone
automatically
OFF:
Use default clock setting.

Set the alarm timer

In standby mode, you can use the daily timer setting
to turn the unit on automatically at a certain time ev-
eryday under standby mode. However the clock must
be set correctly for the timer function to work.
1 In standby mode, press and hold the TIMER
button, hour indicator will blink.
2 Set the hour with the
3 Press the ENTER or TIMER button, minute indicator
will blink.
4 Set the minute with the
5 Press the ENTER or TIMER button or ENTER
button, the selected time is set.
6 Set the daily timer to "ON" (daily timer set is in
effect) or "OFF" (daily timer set is to cancel) with
the button or button.
 
button or button.
 
button or button.
 
37