Set The Sleep Timer; Troubleshooting - Vieta Home VH-MS350SL Manual De Usuario

Note:
* The operating time of every step shouldn't be
longer than 15 seconds or it will return to time
display.
* The sound source of the "timer on" mode is the
same as the sound source when the unit was turned
off by the standby switch.
To confirm the daily time

Press the TIMER button in standby mode, the
daily time is displayed. Wait for a second until the
display returns to the time display.
To cancel the daily timer setting

In standby mode, repeatedly press the TIMER
button until the "ON" will display, then you can set
the daily timer to "OFF" by pressing the
or button (the daily timer will be cancelled).

Turning off the system also cancels the daily timer.

Set the sleep timer

Use the sleep timer to turn the system off after a cer-
tain number of minutes when in play mode. By setting
the sleep timer, you can fall asleep to music and know
that your system will turn off by it self rather than play
all night.
1 Play a disc or tune in to the desired station.
2 To set the sleep timer by press the SLEEP button
repeatedly, it changes the number of minutes
shown on the display in this sequence:
After setting the number of minutes for the sleep
timer, the display will return to the display as be-
fore setting the sleep timer.
The system is now set to turn off after the number
of minutes you set.
To confirm the sleep time

When the SLEEP button is pressed once, the re-
maining sleep time is displayed. Wait for a second
until the display returns to the original display.
To cancel the sleep timer setting

Repeatedly press the SLEEP button until the "00"
is displayed.
Turning off the system also cancels the sleep
timer.

Troubleshooting

To keep the warranty valid, never try to repair the sys-
tem yourself. If you encounter problems when using
this unit, check the following points before requesting
service.
38
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
No disc detected
- Check if the disc is inserted upside down.
- Wait until the moisture condensation at the lens
has cleared.
- Replace or clean the disc.
- Use a finalized CD or correct format disc.
Remote control does not work
- Before you press any function button, first select
button

the correct source.
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
Disc does not play
- Insert a readable disc and ensure that the label
side faces up.
- Check the disc type, color system and regional code.
Check for any scratches or smudges on the disc.
- Press MENU to exit the system setup menu.
- Disable the password for parental control or change
the rating level.
- Moisture has condensed inside the system.
Remove the disc and leave the system turned on
for about an hour. Disconnect and reconnect the
AC power plug, and then turn on the system again.
Poor radio reception
- Increase the distance between the unit and your
TV or VCR.
- Fully extend the FM antenna.
- Connect an outdoor FM antenna instead.
Audio or subtitle languages cannot be set
- The disc is not recorded with sound or subtitles in
multiple languages.
- The audio or subtitle language setting is prohibited
on the disc.
Cannot display some files in USB device
- The number of folders or files in the USB device
has exceeded a certain limit. This phenomenon is
not a malfunction.
- The formats of these files are not supported.
USB device not supported
DVD Microsystem