Technical Specifications; Regulatory Compliance - Clarity Professional C120 Manual Del Usuario

TECHNICAL SPECIFICATIONS
C120 TRANSMITTER INFORMATION
Dimensions: 7 1/16"L x 3 5/8"W x 1 1/8"H, (17.9cm x 9.2cm x 2.8cm)
Weight: 5.2 oz (147g)
AC Adapter: 100-240V, 50/60 Hz, 0.15 Amps
Charging Docks: Charges one (1) C120 headset and two (2) additional
batteries in the auxiliary docks.
Auto Off Power: Transmitter turns off after it has not detected audio
signal for 90 seconds.
Transmitting Frequency: 2.3MHz and 2.8MHz
Transmitter Range: Approx. 38ft
Microphone Input: 3.5mm jack for supplied TV microphone.
Audio Cable Input: One (1) RCA cable, one (1) RCA to 3.5mm cable
C120 HEADSET INFORMATION
Weight: 1.75 ounces (49g) without battery, 2.05 ounces (58g)
including battery
Frequency Received: 2.3MHz and 2.8MHz from transmitter, 95kHz
from public IR systems.
Controls: "Home/Away" switch to set the headset to proper frequency,
volume wheel, tone and balance controls.
Amplified dB Level: 50dB, 124 dBSPL
Battery Type: Nickel Metal Hydride (NiMH), Rechargeable, weight
is 0.3 oz
Battery Life: Four (4) hour usage time, four (4) hour charge time,
lasts 500 charges.
All manuals and user guides at all-guides.com
16

REGULATORY COMPLIANCE

Part 68 of FCC Rules
Information
a) This equipment complies with
Part 68 of the FCC rules and the
requirements adopted by the ACTA.
On the bottom of this equipment is
a label that contains, among other
information, a product identifier in
the format US:AAAEQ##TXXXX.
If requested, this number must be
provided to the telephone company.
b) A plug and jack used to connect
this equipment to the premises
wiring and telephone network must
comply with the applicable FCC Part
68 rules and requirements adopted
by the ACTA.A compliant telephone
cord and modular plug, RJ11C
USOC, is provided with this product.
It is designed to be connected to a
compatible modular jack that is also
compliant. See installation instruc-
tions for details.
c) The REN is used to determine the
number of devices that may be con-
nected to a telephone line. Excessive
RENs on a telephone line may result
in the devices not ringing in response
to an incoming call. In most but not
all areas, the sum of RENs should
not exceed five (5.0).To be certain of
the number of devices that may be
connected to a line, as determined
by the total RENs, contact the local
telephone company. For products
approved after July 23, 2001, the
REN for this product is part of the
17
product identifier that has the format
US:AAAEQ##TXXXX.
The digits represented by ## are the
REN without a decimal point (e.g., 03
is a REN of 0.3). For earlier products,
the REN is separately shown on the
label.
d) If this telephone equipment causes
harm to the telephone network, the
telephone company will notify you in
advance that temporary discontinu-
ance of service may be required. But
if advance notice isn't practical, the
telephone company will notify the
customer as soon as possible.Also,
you will be advised of your right to
file acomplaint with the FCC if you
believe it is necessary.
e) The telephone company may make
changes in its facilities, equipment,
operations or procedures that could
affect the operation of the equip-
ment. If this happens the telephone
company will provide advance notice
in order for you to make necessary
modifications to maintain uninter-
rupted service.
f) If trouble is experienced with this
telephone equipment, for repair or
warranty information, please con-
tact Clarity, 1-800-552-3368. If the
equipment is causing harm to the
telephone network, the telephone
company may request that you
disconnect the equipment until the
problem is resolved.