Normal Grinding Operation; Programming Grind Dosing Times - Baratza VARIO Manual De Operación

Normal Grinding Operation

Press the desired button (Espres-
so, Filter or Press). The blue LED
next to the button will light and the
display LCD will show the corre-
sponding programmed grind time
in seconds. Press START button
to begin grinding. While grinding,
the LCD will count down the sec-
onds to 0. When the LCD reaches
0 seconds, the motor will stop and
the display will reset again to the
programmed time.
quantities of ground coffee, press
the MANUAL button then START.
The grinder will count up to a limit
of 90 seconds then shut off auto-
matically. At any time during MAN-
UAL, you can stop the grinding by
pressing the START button. The
motor will stop and the LCD will re-
set to 000. The limit of 90 seconds
is not user adjustable.
Programming Grind Dosing
Times
The VARIO is equipped with
™
three programmable dosing grind
times. The buttons are convenient-
ly labeled for Espresso, Filter and
Press. These programmable but-
tons only adjust the grinding TIME,
they do not adjust the coarseness
of the grind. Each button comes
from the factory with a preset time:
Espresso: 10 seconds, Filter: 20
All manuals and user guides at all-guides.com
For greater
6
seconds and Press: 30 seconds.
After adjusting the grind (particle
size) to your desired setting, press
the desired button, and then press
START. The grinder will run and
the display will count down from
the preset time.
The grinder will stop automatically
when time reaches 0. To stop at
any time during grinding, just press
the START button again. Depend-
ing on the amount of coffee ground,
you can easily program more or
less grinding time as follows:
1. Press the up or down arrow just
below the LCD display to adjust
the time. Press and hold the arrow
for 3 second to advance the time
more quickly.
2. Once you have reached the de-
sired time setting, press the corre-