Important Instructions - PALSON Diabolo Modo De Empleo

GB
Our products are developed to reach the highest standards of quality, functionality and design. We
hope you enjoy your new PALSON DIÁBOLO robotic vacuum cleaner.

IMPORTANT INSTRUCTIONS

The robotic vacuum is recommended exclusively for indoor use. It is suitable for hardwood floors,
linoleum, tile and shallow or medium carpets. To make sure you get the most out of your robotic
vacuum, please read this instruction manually carefully.
1. Before starting your robotic vacuum, make sure the battery is fully charged.
2. Press i/O (11). There are three start buttons (9): S, M and L (small, medium and large) for selecting
the size of the room you want to clean. Room dimensions and the corresponding operating times are
shown below:
S 10-15 m 30 minutes
2
M 15-25 m 40 minutes
2
L over 25 m 2 60 minutes
3. If you want your robot to avoid a certain area, place
the virtual wall (1) in the appropriate location.
4. If you press the wrong start button, press the correct
button twice to make the device start cleaning.
To use the virtual wall unit (1), follow this diagram:
Power light
Power button
10
All manuals and user guides at all-guides.com
Ideally the virtual wall
should be placed next
to the door
Range selector
Infrared emitter
The virtual wall unit (1) uses two batteries (LR20) to divide the infrared emission distance into three
options, as shown in the following diagram:
Over 7 metres
3-7 metres
0-3 metros
Select one of these options according to what you want to clean.
CAUTION: Do not look at the infrared light.
5. After pressing one of the three start buttons (9), you will hear a sound and the vacuum will start
working.
6. The device will take 30-60 minutes to clean a regular sized room. When the battery is running low,
the battery level indicator (8) will turn red and the system will switch off automatically.
The robotic vacuum is simple to use and requires minimal maintenance. To guarantee optimum
performance, always follow these steps:
Cleaning the removable tank (10)
There are two ways to remove dust and dirt from the tank:
1. Empty the removable tank (10):
a) Turn off the device.
b) Depress the tab on the tank (10) and remove it as shown in the following diagrams:
c) Clean the tank (10).
2. Clean the filter (5):
a) Place the tank (10) upside down.
b) Lightly press the button and remove the filter (5) as shown in the following diagram:
11