A.I.&.E MEMPHIS AJ140-S Manual De Instrucciones página 12

switches the heater off and prevents the heater operating, take the
heater to your nearest service center for inspection and repair.
ATTENTION! Before restarting the heater, it must be
unplugged for at least 10 minutes.
Note: This product equipped open window detection function, when
the products detected the room temperature decreased over 3
comparing to the temperature set within 0.5 hour, the unit will stop
providing the heat and the display screen will show "00".
USING THE MANUAL AND REMOTE CONTROLS
Note:
Before using the fireplace please make sure set the toggle switch(5)
to the position I. Set the toggle switch(5) to the position O if you
would like to turn off the unit. On the top-right side plate of the electric
fireplace is the control panel(6). This panel contains the buttons to
properly operate the electric fireplace. The buttons on the control
panel on the side of the electric fireplace and the remote control
function in the same way. The remote control has an effective range of
up to 13 feet.
1. Ventilation slots
2. Safety bracket
3. Glass panel
4. Power cord and plug
5. ON/OFF switch
6. Control panel
7. Remote control
8. Digital display unit
9. Function indicator
10. Power ON/OFF button
11. Flame control button
12. Thermostat button
13. Timer button
14. Week timer
15. Week timer adjustment
12