Scott Living 1023VA-36-201 Instrucciones De Montaje, Cuidado Y Uso página 5

VANITY CABINET WITH BASE INSTALLATION INSTRUCTIONS
3. Locate Vanity Cabinet (A) and remove both
the upper and lower drawer (F). To remove
drawers (F), extend the drawer fully out one
by one and depress the handles on both
sides of the glides located on the bottom front
corners under the drawer boxes. Both
handles need to be depressed in at the same
time to release the drawer box from the glides
then gently lift up drawer box from glide track.
Repeat for second drawer (F). Do not force
the drawer box out. Set drawers aside.
Assembly Instructions for use with Vanity
Base Assembly. If Vanity Cabinet (A) will be
used as a Wall Mount without Base then skip
to step (9).
4. Carefully place Vanity Cabinet (A) on its back
side onto a scratch free surface. Locate
completed Base Assembly from Step 2 and
set next to Vanity Cabinet (A). Insert 4 Wood
Dowels (FF) into pre-drilled holes in bottom
side of Vanity Cabinet (A). With the help of
another adult, gently slide the Base Assembly
to the bottom of the Vanity Cabinet (A). Make
sure the Wood Dowels are aligned well
between the Vanity Cabinet (A) and Base
Assembly. Using the included Allen Wrench
(DD) secure Base Assembly to the bottom of
the Vanity Cabinet (A) through the Base Top
using Short Bolt (GG), Lock Washer (EE) and
Washer (BB). Do not over tighten Short Bolts
(GG).
Hardware Used
Short Bolt
GG
Washer
BB
Allen Wrench
DD
Lock Washer
EE
Wood Dowel
FF
3
4
A
x 4
x 4
x 4
x 4
5
A
F
F
GG
BB
EE