Scott Living 1023VA-36-201 Instrucciones De Montaje, Cuidado Y Uso página 7

VANITY CABINET WITH BASE INSTALLATION INSTRUCTIONS
7. Locate Top (B) and set aside.
TIP: It may be easier to install faucet and
drain set (not included) to Top (B) at this
time.
With the help of another adult, apply a bead
of silicone adhesive (not included) to the top
edge of the Vanity Cabinet (A) and back side
of Top (B) where it rests against the wall.
Lower Top (B) onto Vanity Cabinet (A). Wipe
any excess silicone from both the outer and
inner edges of where the Top (B) rests on
the Vanity Cabinet (A). Allow silicone to dry
for 24 hours before use.
8. Locate upper and lower drawer (F) and set
aside. Fully extend lower drawer glide tracks.
With the help of another adult, hold the
extended glide in one hand and the drawer in
the other. Gently place the back of the drawer
box into the metal hook located on the back
of the drawer track. Once the glide hook has
been slid into the hole in the back of the
drawer box, gently lower the drawer box
down onto the extended glide tracks. At the
same time depress both of the glide handles
and allow the drawer box to fully rest on the
glide tracks. Test to see if the drawer box is
fully engaged. If the drawer box can still be
lifted off the glide track then start again from
the beginning. Never force anything or else
damage to the drawer or glide hardware could
result. Repeat for both drawers. The drawers
location can be adjusted slightly up or down by
twisting the adjuster knob next to the glide
handles.
7
B
3
8
A
7
1
2
3
B
F