Product Description - Adler AD 2834 Manual De Uso

14.In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
15.If using the device in bathroom after use remove the power plug from the socket,
because water proximity presents risk, even if the device is turned off.
16. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
17. Do not handle the power adapter with wet hands.
18. Always switch the device off whenever you put it down.
19. Do not leave the device or the power adapter in the socket unattended when it is
switched on.
20. If the device uses a power adapter, do not cover it as this could lead to a dangerous
increase in temperature and damage to the device. Always insert the plug into the power
socket on the device first, and then insert the power adapter into the power socket.
21. The cutters are very sharp. Exercise caution during assembly, disassembly and
cleaning. Do not touch the moving parts of the blades while the device is operating!
22. DO NOT CHARGE THE BATTERY FOR MORE THAN 48 HOURS - it may cause
irreparable damage.
23.The charging process should be carried out at temperatures between 5 and 35
degrees Celsius.
24. Only change the combs when the trimmer is turned off.

PRODUCT DESCRIPTION:

1. Blade Head 2. Cutting Length leaver 3. Speed button / Power Button 4. Charging base
5. LCD Display 5a. Oil Indicator 5b. Speed Indicator
6 Charging Socket 7. Combs 7a. Cleaning Brush 7b. Oil bottle
CHARGING THE BATTERY:
To begin charging plug the power cord into the charging Socket (6) or charging base, and the charger into a 220-240V~ 50/60Hz mains
power outlet.
Once plugged or put on a powered stand, the charging indicator icon (5d) will light up and the remaining battery (5c) will start blinking
from bottom to top and back again showing the loaded .
After the battery is fully charged the remaining power indicator will stop blinking unplug the device from the charger.
The charging time is about 3 hours. After that the product is full charged, the running time is about 240 minutes on 5.0k RPM and
180 minutes on 7.0k RPM.
Note: When it runs out of battery, you can use it while charging.
SPEED CONTROL BUTTON (4) Speed Indicator (5b)
Motor speed range : 5 speed levels are available 5000-7000 RPM
Every time you press the button (3), it will adjust 500 RPM (5b)
POWER BUTTON (4)
Press the power button (4) for 2 seconds to turn it off or once to turn it on.
OILING INDICATION (5a)
When the product working all time by 60 minutes, the oiling indicator (5a)will appear to remind you to clean and oil the blade (please
look point with cleaning method).
USING THE CLIPPER
5c. Battery Remaining Capacity 5d. Charge Indicator 5e. Burden
5