Troubleshooting; Specifications - IK Multimedia iLoud Micro Monitor Manual Del Usuario

English

Troubleshooting

I have connected my device to iLoud Micro Monitor, but no sound comes out.
Make sure to set up the volume with the volume potentiometer on iLoud Micro Monitor and/or with your
device's volume control.
Sound is distorted.
When a noticeable distortion occurs, please turn down the level of the speakers, or of the connected audio
source.

Specifications

- Type: 2-way active, bi-amped, studio monitor
- Frequency response (-3dB): 55Hz - 20kHz
- Frequency response (-10dB): 45 Hz - 22 kHz
- Crossover Frequency: 3kHz
- Tweeter: 3/4" silk dome and neodymium magnet
- Woofer: 3" paper cone
- Maximum SPL @ 50cm (with two speakers playing, averaged sinewave from 100 Hz to 10 kHz): 107dB
- Number of amplifiers: 4
- Amplifiers type: Class-D
- Total output power (both speakers): 70W (peak) - 50W RMS
- Woofer output power (single speaker): 18W RMS
- Tweeter output power (single speaker): 7W RMS
- Acoustic settings: high shelf (0dB or +2dB from 4kHz up); low shelf (0dB or -3dB from 250Hz down); desktop
(+3.5dB between 1kHz and 10kHz and -1dB below 400Hz)
- High performance Bass-Reflex port
- Bluetooth compatible with A2DP protocol
®
- 56-bit DSP internal resolution
- System total latency (analog input): 1.02 ms
- System total latency (Bluetooth input): 155 ms (depends on host implementation, tested on iPhone 6S / iOS
10.0.1)
- Connectors: 2x RCA unbalanced input; 1/8" AUX stereo input (unbalanced); 4-pin speakers connector
- Dimensions (inches): 180mm x 135mm x 90mm (7" x 5.31" x 3.54")
- Weight (oz): 920g (32.45oz) left speaker - 800g (28.22oz) right speaker
18