ENG
Safety
Read instructions for use.
If the unit is damaged, contact Lumie before use.
Keep away from water and damp.
For indoor use only.
The unit gets warm when the light is on, so make sure that it is not covered.
Use only the mains power adaptor supplied.
Keep the mains power adaptor and cable away from heated surfaces. If either are damaged,
they should be replaced with an approved Lumie product.
To power down or reset, remove the mains power adaptor from the wall socket. You should
therefore ensure the socket is easily accessible.
Caution – do not attempt to service or modify any part of the unit.
If the unit has been stored outside the recommended operating temperature range (5 °C to
35 °C), allow it to stand for at least 1 hour before applying power to avoid condensation or
overheating.
The light source contained in this luminaire shall only be replaced by Lumie or an authorised
Lumie distributor.
Electromagnetic compatibility
Electrostatic discharge may affect the working of this product. If this occurs, simply switch
off for at least 10 seconds and the unit will reset.
Disposal
Do not throw out the mains power adaptor or the unit with normal domestic waste. Take
them to an official recycling point to be disposed of responsibly.