Water Heaters - GALA Next Manual De Usuario

INTRODUCTION
Dear customer,
Congratulations on having chosen a hydromassage
cabin Next.
We advise you to read these pages carefully and, if you
require any clarification, contact your distributor.
Your hydromassage cabin Next has been individually
checked and has passed the strictest controls,
guaranteeing both the quality of the materials and the
functioning of all components.

WATER HEATERS

Accumulator tanks
For accumulator tanks of less than 100 litres, we
recommend
General Considerations
- For your hydromassage cabin Next to function
correctly, the water supply pressure must not be higher
than 5 bar or lower than 2 bar. For safety reasons,
however, it must not exceed 55ºC. Always respect
these limits. If the pressure or temperature of the water
entering the column is higher, this may damage the
product. On the other hand, if the pressure of the water
is lower, your hydromassage cabin Next may not
function correctly.
- The thermostatic tap regulates the temperature by
activating the thermostatic cartridge. If the boiler
switches off too often and cold water comes out when
using any of the functions of the hydromassage cabin
Next , clean the filters of the thermostatic taps and, if the
problem persists, reduce the temperature of hot water
coming from the boiler or heater with the appropriate
control on the device. In all cases, consult the technical
characteristics of the boiler.
HYDROMASSAGE
Before a hydromassage:
certain function of your hydromassage for some time,
the anti-limescale injectors should be checked as
indicated in the hydromassage maintenance
instructions.
Pressure of the water jet: Regulate the water flow for a
more or less powerful massage. Combinations of the
type and duration of massage and the temperature of
the water enable you to adapt the hydromassage to
your requirements.
In general, the intensity of the water jet has the following
effects:
-Greater intensity: toning effects
-Less intensity: relaxing effects
The hydromassage should never be excessively
strong.
Temperature of the water: we recommend that this be
between 30 ºC y 39 ºC:
if you have not used a
turning the thermostat up to the highest possible
temperature, as otherwise the hot-water hydromassage
will last no longer than a few minutes. For safety reasons,
however, it must not exceed 55º C.
Instant heaters
If you have an instant heater or combi boiler, this must be
able to provide the stipulated pressures and
consumptions. If it has useful power of less 20,000
kcal/hour, it may not be able to maintain the temperature
when using certain functions.
Instant heater-accumulator tank combination
systems
This is the recommended configuration, with tank volume
of not less than 50 litres.
.
OPERATING INSTRUCTIONS
Hydromassage
-Cold (30 - 35ºC). With mainly toning effects.
-Neutral (36 - 37ºC). For relaxing effects.
-Hot (37 - 39ºC). For muscular applications.
Thermostatic tap. You can select the desired
temperature by means of the "temperature indicator
control". Turn the on-off control until you reach the
desired water flow rate. The water will be at the
temperature you have selected.
On the "temperature indicator control", there is a safety
button that prevents temperatures over 38ºC being
selected by mistake. If you want a higher temperature,
press the button to unblock this safety mechanism.
Hydromassage process: Select the desired function
using the function selector, which permits the following
options:
•Massage with the hand-shower.
possible functions to specific parts of the body.
•Body massage with the upper adjustable-direction
vertical jets. For application over a wide area of
theupper body.
•Body massage with the lower adjustable-direction
vertical jets. For application over a wide area of the
lower body.
•Foot-level water outlet.To check the temperature.
Turn the 16-outlet jets, equipped with an anti-limescale
device, in the most appropriate direction, though you can
later change it to direct the water jets onto whatever parts
of the body you want.
•Adjust the temperature of the water, checking it at the
foot-level outlet.
•Select the appropriate function.
•Turn the water on progressively until you obtain the most
appropriate hydromassage pressure.
3 3
Adapting its