Deuba DBDL005 Manual De Instrucciones página 16

• Make sure that the compressor used has the
right amount of power for the compressed air
tool → CFM
• Do not exceed the maximum air pressure of the
device during use. If the air pressure is too high
or the air supply is contaminated, there will be
greater wear and tear on the tool.
•
gets into the tool it can cause damage.
• Always use the proper hose and hose connector.
It is not recommended to connect the quick
connect adapter directly with the device, as
A guide hose should be used to make the
• The tubes should be kept away from heat, oil
and sharp edges. Check for wear before each
ASSEMBLY
1. The stop bracket can be removed when
changing the saw blade but it must always be
put back in place before use. Using the device
without the stop bracket can lead to serious
injury! To remove the stop bracket, loosen the
two adjustment screws with the Allen key as
shown. To put it back in place again, place it
adjustment screws with the Allen key again.
Adjustment Screw
Saw Blade
Atop Bracket
2. To change the saw blade, open the chuck cover
it upwards.
Allen Key
Chuck Cover
Adjustment Screw
Allen Key
3. Using the Allen key as shown, loosen the
two adjustment screws to remove the saw
adjustment screws. Close the chuck cover then
will damage the threads.
Chuck Cover
Adjustment Screw
Allen Key
USE
be angled to rest on the sheet to ensure a smooth
4. When the saw blade is securely installed,
press the safety lever forward so the trigger
trigger.
5. Now operate the device with both hands to
force on it.
6.
the device from the air supply to prevent
accidents. Expel any residual pressure safely
from the device.
ww w.DeubaXXL.de
Saw Blade
Saw Blade
16