Publicidad
Idiomas disponibles
Idiomas disponibles
5. Drill into wall at two marked locations with an
appropriate drill bit.
6. Use rubber mallet to gently tap anchors into
drilled holes.
7.
Hold dispenser over anchors and insert screws.
(See Figure 3)
Figure 3
1.
Using the key, push release latch to open front cover
of dispenser. The latch is located on the top edge in
the center. (See Figure 5)
2. Remove cardboard covering along perforations of
bandage refills. (See Figure 6)
PAGE 2 OF 6
MOUNTING INSTRUCTIONS CONTINUED
LOADING INSTRUCTIONS
Figure 5
Figure 6
1-800-295-5510
TAPE MOUNTING
1.
Remove backing from both sides of adhesive strips.
2. Place adhesive strips on backside of dispenser in
designated locations. (See Figure 4)
Figure 4
3. Place dispenser in ideal mounting spot and press
evenly to secure to wall.
3. Slide bandage refills through bottom of dispenser
until in locked position. (See Figure 7)
Figure 7
4. Close front cover of dispenser.
uline.com
0621 IH-7983
Publicidad
