GE 20 Manual Del Propietario E Instalación página 31

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WHAT YOU WILL NEED
NOTE: The only GE approved plastic tubing
is that supplied in GE SmartConnect
Refrigerator Tubing kits. Do not use any other
plastic water supply line because the line is
under pressure at all times. Certain types of
plastic will crack or rupture with age and cause
water damage to your home.
• A GE water supply kit (containing tubing,
shutoff valve and fittings listed below) is available
at extra cost from your dealer or from Parts and
Accessories, 800.626.2002 (in Canada
1.800.661.1616).
• A cold water supply. The water pressure must
be between 20 and 120 p.s.i. (1.4–8.1 bar).
• Power drill.
1/2 or adjustable wrench.
• Straight and Phillips blade screwdriver.
• Two 1/4 " outer diameter compression nuts
and 2 ferrules (sleeves)—to connect the copper
tubing to the shutoff valve and the refrigerator
water valve.
OR
• If you are using a GE SmartConnect
Refrigerator Tubing kit, the necessary fittings
are preassembled to the tubing.
• If your existing copper water line has a flared
fitting at the end, you will need an adapter
(available at plumbing supply stores) to connect
the water line to the refrigerator OR you can cut
off the flared fitting with a tube cutter and then
use a compression fitting. Do not cut formed end
from GE SmartConnect
• Shutoff valve to connect to the cold water line.
The shutoff valve should have a water inlet with
a minimum inside diameter of 5/32 at the point
of connection to the COLD WATER LINE. Saddle-
type shutoff valves are included in many water
supply kits. Before purchasing, make sure a
saddle-type valve complies with your local
plumbing codes.
All manuals and user guides at all-guides.com
Installation Instructions
(CONT.)
Refrigerator tubing.
Install the shutoff valve on the nearest frequently
used drinking water line.
SHUT OFF THE MAIN WATER SUPPLY
1
Turn on the nearest faucet long enough
to clear the line of water.
CHOOSE THE VALVE LOCATION
2
Choose a location for the valve that is easily
accessible. It is best to connect into the side
of a vertical water pipe. When it is necessary
to connect into a horizontal water pipe, make
the connection to the top or side, rather than at
the bottom, to avoid drawing off any sediment
from the water pipe.
DRILL THE HOLE FOR THE VALVE
3
Drill a 1/4" hole in the water pipe (even if using
a self-piercing valve), using a sharp bit. Remove
any burrs resulting from drilling the hole in
the pipe.
Take care not to allow water to drain into the
drill.
Failure to drill a 1/4" hole may result in reduced
ice production or smaller cubes.
31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2223Gdsc3kcybb

Tabla de contenido