Charging Indicator; Failure Analysis - Dexter 12VBA2-20.5 Instrucciones Legales Y De Seguridad

HOW TO CHARGE THE BATTERY PACK
Note: This Lithium-Ion battery pack is shipped partially charged. Fully charge the battery
before using it for the rst time.
pack
Charge the Lithium-Ion battery pack only with the correct charger.
Align the raised ribs of the battery pack with the slot in the charger.
Connect the charger to a power supply.
Insert the battery pack into the charger.

CHARGING INDICATOR

Note: Press the light button to check the battery pack whether needs to charge.
Lights
Three blue lights
always on
Two blue lights on
One blue lights on
Note: Immediately after using the battery pack, the charge level button may display
alower charge than it will if checked a few minutes later. The battery cells "recover"
some of their charge after resting.
6. FAILURES ANALYSIS
Problem
When charging the battery pack, the
charging indicator does not light when
the chargeris connected to the AC
power supply.
The machine does not work or stop
working after rotating slowly when
connecting the battery with the
Light indicators
Reasons and solution
1.poor contact: Please pull out the battery
pack and reconnect to charge.
2.The battery pack is bad: After the charge
risconnected to the AC power supply, the
charging indicator light is on but the
battery still cannot be charged. Please
replace the battery pack.
The battery is in low power.
Need to charger the battery pack before
operating.
86
Status
The Voltage 11.3V
"OK to store"
TheVoltage 10.3V
"OK to store"
The Voltage 6.8V
Requires to be charged
"OK to store"
FR
ES
PT
IT
EL
PL
UA
RO
EN