Pre-Heating Function - Ferroli ROMEO N Manual De Usuario

3.4 Pre-Heating function

This function is active only if automatic heating mode has been selected.
When set to Automatic, the function anticipates the heating system start time (not before 00:00 of the same day) so that the room
temperature set by the user is reached at the start of the programmed band. The Remote Control calculates a first hypothetical
Pre-activation time: if the programmed room temperature is reached in a shorter time than the calculated one, the Pre-Heating time
will be decreased and vice versa. In this way self-learning is created, for determining the shortest Pre-activation time necessary.
The Remote Control also offers the possibility of setting a fixed Pre-Heating ramp: in this case the room temperature will be
raised by 3°C per hour.
The automatic heating program should therefore be programmed according to the time when warmth is wanted, and not the
desired heating system start time.
Follow the instructions below to activate or deactivate this function.
1. Press the button
2. The display shows parameter CU.
3. Press the button
Set to 0 using the buttons
activate Automatic Pre-Heating. Set to 2 using the buttons
3°C per hour.
4. Press any other button to exit the menu.
During the pre-heating function, the room temperature °C symbol blinks.
The pre-heating function ends when the difference between the programmed and actual room temperature is less than 0.5°C.
EN
130
for 3 seconds.
repeatedly until parameter P2 is displayed.
/ to deactivate Pre-Heating. Set to 1 using the buttons
code 3541Z220 - Rev. 05 - 12/2021
/ to activate Pre-Heating with fixed ramp of
/ to