Installation; Operation - Proline PBR46W-E Manual De Instrucciones

INSTALLATION

Position the appliance and allow it to stand for two to three hours before it is turned on for the first time
to allow the system to settle. Do not position next to any heat source e.g. cooker ,boiler or in direct
sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space on both sides of the appliance and between
the back of the appliance and the wall for adequate air circulation. The appliance is not designed for
recessed installation ("building in").
Install on a good firm level surface, and any unevenness of the floor should be corrected prior to
installation, slight unevenness can be overcome by adjusting the front feet.
NOTE NOTE
NOTE NOTE: If the appliance is positioned on a carpet, soft floor covering you should readjust the front feet
once the appliance has had time to settle.

OPERATION

This appliance is designed to operate in ambient temperature between 16℃and 38℃. If these
temperatures are exceeded, i.e. colder or warmer ,the appliance will not operate correctly. If the
ambient temperatures are exceeded for long periods, the temperature in the fridge will rise above 4℃
and food spoilage may occur .
Remove all packaging materials from the appliance. Wash the inside of the cabinet with lukewarm
water and bicarbonate of soda (5ml to 0.5 litre of water). Dry the appliance thoroughly.
When you use the fridge for the first time or after defrosting, set the thermostat to the maximum
position for at least 2 hours, and then readjust to the normal position.
Setting Setting Setting Setting the the the the temperature temperature control temperature temperature
The refrigerator is controlled with a temperature control knob located inside the appliance, towards the
upper right-hand corner . Turn the knob clockwise from the STOP (OFF) position towards the higher
numbers for colder temperatures.
Higher settings on the knob (higher numbers) mean lower temperatures
(colder) in the appliance.
Changes of the ambient temperature affect temperature in the interior of
the appliance so choose a correct setting of the temperature control knob,
depending on your ambient conditions.
In the STOP (OFF) position the appliance does not operate (the cooling
system is switched off), but power supply is not interrupted.
The storage temperature may be affected by:
� The room temperature
� How often the door is opened
� How much food is stored
� Position of the appliance
When you set the correct temperature, all these factors mentioned above shall be taken into account.
All manuals and user guides at all-guides.com
control control control
5