Intended Use; Safety Requirements - GCE KOMBI 17 Instrucciones De Uso

ENGLISH
INSTRUCTION FOR USE: CUTTING AND WELDING SET
1. FOREWORD
The product complies with the essential requirements of standards:
• ISO EN 5172 - Gas welding equipment - Blowpipes for gas welding, heating
and cutting – Specifi cations and tests
EN
• EN 560 – Gas welding equipment - Hose connections for equipment for
welding, cutting and allied processes
• EN 1256 Gas welding equipment -Specifi cation for hose assemblies for
equipment for welding, cutting and allied processes
• EN ISO 3821 Gas welding equipment - Rubber hoses for welding, cutting
and allied processes
• ISO 5175-1 - Gas welding equipment. Safety devices. Incorporating a fl ame
(fl ashback)arrestor.
• ISO 5175-2 - Gas welding equipment. Safety devices. Not incorporating a
fl ame (fl ashback) arrestor
• ISO 5175 - Equipment used in gas welding, cutting and allied processes
- Safety devices for fuel gases and oxygen or compressed air -- General
specifi cations, requirements and tests

2. INTENDED USE

Welding and Cutting set KOMBI 17, 18, 20, 2001,CZ, RK20 is intended for use with
oxygen and fuel gases.

3. SAFETY REQUIREMENTS

All indications showing this exclamation mark
tions.
• Installation and operation of the equipment must be only done by qualifi ed
personnel in accordance with local directions, rules and standards.
• The product should be used at temperature from -20°C to +60°C.
• Use only nozzles that are recommended by producer of this cutter (see App.
Nr. 1).
• Use safety devices that are recommended by producer or required by na-
tional standards in each country.
• For safety reasons all shut-off valves should to be opened slowly and
smoothly.
• Check that all ventilation grills are free from obstruction and that the extrac-
tion system (when installed) is functioning correctly.
• National laws, rules and regulations for compressed gases, accident pre-
vention and environmental protection must be observed.
Keep the product and its associated equipment away from: oil or grease - al-
ways wash your hands prior to handling the product or the cylinder; water;
dust; fl ammable substance and materials.
are important safety instruc-
14/64