Quick Menu; Usb Mode - Haier LE26A300 Manual De Usuario

All manuals and user guides at all-guides.com
Phase : This is used for adjusting the phase of pixel clock
in PC mode.

Quick Menu

Press Q.MENU button to enter, This function includes
some usual oprations about Picture,Sound,Color
Tempeature, Sleep Timer, Aspect Ratio and Backlight.

USB MODE

Note
❏
The diagrams in the following section are
schematic and only for your reference. Please see
the actual product if necessary.
TO USE THE USB DEVICE
A
Supported file formats:
Photo: *.jpg,*.bmp;
Music: *.mp3,*.wma;
Movie: *.AVI,*.mpg,*.DAT,*.TS,*.MOV,*.mp4,*.VOB;
Note
❏
Due to the particularity of file cording, some files
may be unable to read.
❏
The USB Movie player can surpport codes as
MPEG2, MPEG2_HD,MPEG4,MPEG4_HD,H.264.
Some movie files may not be played naturally
when its coding doesn't include in the codes
upwards.
B
Supported equipment:
Support the USB flash disks
Storage Protocol and whose file system is FAT32.
If USB equipment could not be identified due
C
When connecting/removing the USB
device
A
B
C
D
E
that supports Mass
Operating the USB device
to unsupported file system, please format the
equipment to the above-mentioned file system.
To achieve smooth playing, ensure the following:
The file code rate should be lower than 300KB/S;
Due to the limitation of USB signal transmission
distance, it is recommended not to use USB patch
cord, in case of using the cord, make sure that its
length is not over 1m;
Use high-speed USB equipment in conformity
with USB2.0 full speed Interface Standard; If USB
equipment in conformity with USB1.1 full speed
Interface Standard is used, the playing may be
unsmooth.
Press INPUT on the remote control unit to select
USB option.
Insert USB equipment into corresponding USB
interface 2s after starting the system.
After entering the system menu, press
remote control unit to select the require USB files,
press OK button to confirm the selection and enter
the file list relative to the selection.
Press / on the remote control unit to select the
required file, press ENTER button to enter the selected
file.
To exit the streaming media playing system and
watch a TV program, you must press
return to the streaming media main menu at first (to
protect equipment), and then press INPUT to select
AIR or Cable to return to the TV mode.
Note
While playing the USB, press
the screen picture will return to USB main interface,
and only at this time you can switch corresponding
signal sources by pressing INPUT again.
Please do not unplug the USB device when the
connected USB storage device is working. When such
device is suddenly separated or unplugged, the stored
files or the USB storage device may be damaged.
TV LED-TFT Owner's Manual
Operation
/ on the
EXIT button to
EXIT button repeatly,
EN-17