Uline H-7196 Guia De Inicio Rapido página 2

3. Drill into wall with appropriate-sized drill bit. Insert
wall anchors if necessary. (See Figure 3)
Figure 3
4. Temporarily mount dispenser onto wall, sliding
bracket into notches on back of dispenser.
(See Figure 4)
Figure 4
Mounting Bracket
5. Mark final two holes onto the wall where the screws
will be inserted. (See Figure 5)
Figure 5
PAGE 2 OF 9
MOUNTING INSTRUCTIONS CONTINUED
Notches
6. Remove dispenser from wall and drill into the wall at
marked locations. (See Figure 6) Insert wall anchors
if necessary.
Figure 6
7. Place dispenser back onto mounting bracket and
insert last two screws. (See Figure 7)
Figure 7
0721 IH-7196