boso bosotherm diagnostic Manual Del Usuario página 33

4. If the measured body temperature is below
37.5°C, the measurement result is displayed
with a long signal tone.
5. If the measured body temperature is at or
over 37.5°C (as is the case with a fever),
there are 3 short signal tones.
6. After performing a temperature measurement, the boso-
therm diagnostic shows the measurement result con-
tinuously, and switches off after 1 minute. As soon as
the device is ready for a new measurement, there is a
short signal tone and the "º C" symbol begins to blink.
To perform another temperature measurement, press the
START button and the bosotherm diagnostic starts a new
measurement. Once the new measurement is complete,
there is a short signal tone and the new measurement result
is displayed.
7. If the measurement returns a result that is above or below
the specific temperature range for this mode, "H" or "L" is
shown in the display and three short signal tones are emitted.
After about 5 seconds, the bosotherm diagnostic is ready to
measure again.
8. Press the
nostic. The device automatically switches off after 1 minute.
➝ Push START button
or
button in order to switch off the bosotherm diag-
➝ Push
button
➝
➝
33