Dip Switch; Led Indicator - Cudy GS1006P Manual Del Usuario

DIP Switch 1

Standard mode
Numbers 1-4 correspond to PoE Port1 ~ Port4.
This mode makes the PoE Switch operate as a general switch and all PoE ports operate at 10/100/1000Mbps
auto-negotiation
Extend mode
This mode makes the PoE ports of PoE Switch operate at auto-negotiation 10Mbps speed duplex mode only,
but the delivery distance of PoE power and network data can reach 200m
DIP Switch 2
Default:
The factory default mode, can normal communication between port 1~6.
VLAN:
1-4 port can be isolated each other but 1-4 port can connect to 5/6 port after open VLAN to stop
broadcast storm to increase forwarding rate of frame.
Note: After changing the mode, no power failure is required to make the corresponding configuration take
effect

LED indicator

LED Color
Power Orange
DATA Green
PoE Orange
All manuals and user guides at all-guides.com
Off: No Power supply.
Light: Indicates the switch has power.
Off: No device is connected to the corresponding port.
Light: Indicates the link through that port is successfully
Established at 10/100/1000Mbps.
Blink: Indicates that the Switch is actively sending or
Receiving data over that port.
Off: No PoE powered device (PD) connected.
Light: There is a PD connected to port, which
Supply power successfully.
Function
- 2 -