Kobalt KJR 124B-03 Manual De Instrucciones página 13

OPERATING INSTRUCTIONS
14. Tuning AM and FM
a. Press the mode button (M) several times until the AM or FM is shown on the display (F). A
radio station can be tuned to manually or automatically (scan-tuning).
b. Manual tuning: Briefly press the '<<' button (L) or '>>' button (J) to reach the desired
frequency. Each press will increase or decrease the frequency by 0.1MHz for FM and
10kHz for AM range. The frequency is shown on the display.
c. Automatic/Scan Tuning: Press the '<<' button (L) or '>>' button (J) and hold for 2 seconds,
the tuner will automatically seek the first radio station with strong signal and stop at that
station's frequency. The frequency is shown on the display. The '>>' button (J) may be
pressed for 2 seconds again to continue seeking more radio stations at higher frequencies.
The '<<' button (L) may be pressed to seek radio stations at lower frequencies.
15. Storing Stations in Preset Memories
(AM and FM)
There are 5 memory presets for each waveband.
a. To store the current radio station, press and
hold the preset button (K) until the preset
number is shown on the display, then press the
'<<' button (L) or '>>' button (J) to select the
preset number, from 'Preset 1' to 'Preset 5',
you wish to save the station under.
b. Briefly press the preset button (K), the preset
number will flash on the display once and then
stay on, and the station is stored successfully.
Stations stored in the preset memory can be
overwritten by following the same steps.
c. To recall stations from the preset memories,
briefly press the preset button (K) while the unit is in AM/FM mode. The preset number and
station frequency will appear on the display. Press the preset button (K) repeatedly until
the desired preset station is on the display.
11
13
87.50
MHz
FM
1
L K J