Hydraulic Connection - Lamborghini Caloreclima INOVA E 20MC W TOP Manual Para La Instalación Y El Mantenimiento

HYDRAULIC CONNECTION

Fit the supporting hooks and attach the assembly template, moving it up to the wall; fit all the pipes,
starting with the end pipe fittings already mounted on the template: system supply, system return,
cold water, hot water, any gas pipes and electric mains leads with room thermostat.
Once the pipes have been fitted, the end pipe fittings can be removed and ordinary caps fitted,
ready for hydraulic tests to be carried out. The template can be removed or, if left in place, will be
embedded in the wall once finishing operations have been completed (plaster and tiles); only the two
supporting hooks will protrude from the wall, as well as an opening for the connections. Attach the
boiler to the hooks through the holes at the back of the frame, push it up against the finished wall and
fit the two lock nuts onto the hooks.
Make the necessary hydraulic connections using the pipes/tubes supplied, cutting them to the right
length, depending on the distance between the fittings on the boiler and those on the template em-
bedded in the wall.
ADVICE AND SUGGESTIONS ON PREVENTING SYSTEM VIBRATION AND NOISE
- Do not use pipes of reduced diameter.
- Do not use low-radius elbows or fit-
tings that significantly reduce cross-
section.
-
Hot-flushing of the system is recom-
mended in order to eliminate any im-
purities from the piping and radiators
(especially oil and grease) which
might damage the circulator.
LEGEND
C Hot water 1/2"
Gas 1/2" - 3/4" (see cock supplied
G
with the boiler)
F Boiler water supply 1/2" (cold)
AE Electrical supply
M Installation inlet 3/4"
R Installation return 3/4"
GS Holding hooks Ø10 mm.
NOTE: Preview hydraulic female connections.
All manuals and user guides at all-guides.com
87,5
450
415
17,5
GS
M AE C G F R
124
160
225
290
362,5
450
40