Tabla de contenido
Publicidad
Insert (F) through both holes in (B), both holes in (E) until (F) locks in place. TIP: If needed, use a flat tip screwdriver and a rubber mallet to tap (F) into fully
7
inserted position.
FLIP ASSEMBLY AND REPEAT ON OPPOSITE SIDE.
E
E
B
B
Place the cylinder end of (I) shock into position on lid (E). Insert one bolt (CC) through both holes in lid (E) and secure with nut (DD). Tighten nut (DD) until it makes
8
contact with plastic. DO NOT overtighten.
REPEAT ON THE OPPOSITE SIDE.
1
E
F
E
E
I
B
2
CC
6
F
H
3
DD
Publicidad
Tabla de contenido
