Sunny SF-XF9931 Manual Del Usuario página 10

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at
(877-907-8669).
26
6
support@sunnyhealthfitness.com
26
13
Fig.A
7
7
26
13
Fig.B
6
STEP 7:
Turn the Limit Pin (No. 13) on the Left &
Right Safety Bars (No. 7 & No. 6)
horizontally as Fig. B, then tighten the 2
Butterfly Nuts (No. 26) to avoid the safety
tubes disconnecting from the posts while in
use.
When adjusting the height of Left & Right
Safety Bars (No. 7 & No. 6), loosen the 2
Butterfly Nuts (No. 26), then turn the Limit
Pin (No. 13) vertically as Fig. A.
STEP 8:
WARNING: Please ensure sufficient weights
are on the squat stand and the squat stand is
bolted to the ground before using the
resistance bands.
*NOTE: Φ13 Wood Screws and Expansion
Bolts are not included.
If the ground is made of wood material,
secure the 4 Connecting Pieces (No. A) on
Right & Left Stabilizers (No. 3 & No. 4) to
the ground using 4 Φ13 Wood Screws to
bolt the squat stand.
If the ground is cement ground, please mark
the holes on the 4 Connecting Pieces (No.
A), then remove the squat stand, drill the
holes and install 4 Expansion Bolts into the
ground. Move the squat stand back, align the
holes with 4 Connecting Pieces (No. A) to
the 4 Expansion Bolts and tighten them to
bolt the squat stand.
The assembly is complete!
9
or 1-877-90SUNNY