Specifications; General Specifications; Electrical Specifications - Meterman EPM3 Manual De Uso

Specifications

General Specifications

Operating Environment: 0 °C to 40 °C at <80 % R.H.
Power: Single standard 9 V battery, NEDA 1604, JIS 006P, IEC 6F22
Battery life: Approximately 200 hours typical with carbon-zinc battery
Low battery indication: The BATT LED does not come ON when TEST button is
pressed
Dimensions: 153(L) x 72(W) x 35(D) mm. (6.02 x 2.83 x 1.37 in)
Weight: Approximately 218 g (7 oz) including battery
Enviroment: Indoor use
Altitude: 2000 m (6561 ft.)
Overload protection: 600 V ac
Accessories: Test Leads (red, green, and blue) with alligator clips (TL-EPM3), Soft
Vinyl Case, Users Manual, Battery
Agency Approvals
P )s
Safety: Conforms to EN61010-1:2001; CAT III 600V, Pollution degree 2, Class 2;
CSA 22.2 -1010-1, and EN61557-7
EMC: Conforms to EN61326-1. This product complies with requirements of the
following European Community Directives: 89/ 336/ EEC (Electromagnetic
Compatibility) and 73/ 23/ EEC (Low Voltage) as amended by 93/ 68/ EEC (CE
Marking). However, electrical noise or intense electromagnetic fields in the vicinity
of the equipment may disturb the measurement circuit. Measuring instruments will
also respond to unwanted signals that may be present within the measurement
circuit. Users should exercise care and take appropriate precautions to avoid
misleading results when making measurements in the presence of electronic
interference.

Electrical Specifications

Phase Sequence
Input Voltage: 3 phase to phase inputs - 100 V ac to 600 V ac max.
Frequency: 45 to 70 Hz
Operating time: 10 minutes ON maximum at 600 V ac. 10 minutes OFF minimum
at 600 V ac.
3-Phase load: Approx. 7 mA per phase of ac power source
Motor Rotation
Operating time: 10 minutes ON maximum. 10 minutes OFF minimum.
Motor Rotation tester field: 14 mA of 9 V battery
7