Getting Help - LXE MX1-IS Guia Del Usuario

10
Problem
LED is YELLOW when
battery pack is first inserted
in the charger.
LED is YELLOW when
battery pack is in the
CHARGING cycle. The
charge cycle has been
suspended.
When you first put a fully
charged battery pack in the
charger, the LED turns RED,
indicating the battery pack
needs charging.

Getting Help

All LXE manuals are now available on one CD and they can also be viewed/downloaded from the
LXE ServicePass website. Contact your LXE representative to obtain the LXE Manuals CD.
You can also get help from LXE by calling the telephone numbers listed on the LXE Manuals
CD, in the file titled "Contacting LXE". This information is also available on the LXE website.
MX1-IS MULTI-charger User's Guide
Cause
The battery pack is too hot or too
cold to charge.
The battery pack has become too
hot or too cold to continue
charging.
There is nothing wrong with the
battery pack or charger. During
the first few minutes, the charger
checks the battery pack for
correct voltage and charge state.
During this time charge pocket
LED is continuously RED. After
charging is complete, the LED is
GREEN.
Solution
Remove battery pack from the charger and
allow it to adjust to room temperature.
Note: If the battery pack is left in the
charger, it will cool down or
warm to a temperature at which
time the charger will begin the
charge cycle. However, depending
on the temperature of the battery,
it may take 2-3 hours to adjust.
The cool-down of a battery pack is
much quicker if the battery is not
in the charger pocket.
If this is the first time the battery pack has
initiated a temperature fault, remove the
battery pack and allow it to achieve room
temperature. Then try to charge the battery
pack a second time. If the LED is
YELLOW again, the battery pack is
defective, or the temperature of the charger
or battery pack is out of specification.
Do not "top off" a fully charged battery
pack by repeatedly placing it in charger.
E-EQ-MX1ISMCHGROG-C
Appendix